RC-Monster Forums - View Single Post

04.13.2006, 05:43 AM

squee, I messed around with the direction of the tranny/motor plate/drive shafts but this way seemed the best for the drive shafts to fit.

serum, me neither until a week ago, I saw it on a xxx and thought 'I need that'...... as you do.
Time will tell if its worth doing or not,

maxxdude, they are Epic ESP ...3800 and they fit under Mike's bars perfectly :043:

daf, I though I'd only cut out the holes that showed the glue side, and leave the real PITA job of cutting round the screws till I needed too :026:
The speedo site is not perfect agreed, but its always a compromise were to site the damn things. It does mean I can show off the fans though :020:

I know what your thinking ......'cause its been said before

TART:005:

	(#14)
cabking Guest Posts: n/a	04.13.2006, 05:43 AM squee, I messed around with the direction of the tranny/motor plate/drive shafts but this way seemed the best for the drive shafts to fit. serum, me neither until a week ago, I saw it on a xxx and thought 'I need that'...... as you do. Time will tell if its worth doing or not, maxxdude, they are Epic ESP ...3800 and they fit under Mike's bars perfectly :043: daf, I though I'd only cut out the holes that showed the glue side, and leave the real PITA job of cutting round the screws till I needed too :026: The speedo site is not perfect agreed, but its always a compromise were to site the damn things. It does mean I can show off the fans though :020: I know what your thinking ......'cause its been said before TART:005: