RC-Monster Forums - View Single Post

crazyjr · 11:36 PM

The windings are protected like an armature so i don't think they are damaged.

What i wonder about is how the sensors work. i have looked everywhere except behind the end plate and don't see a sensor setup anywhere and nothing to key the rotor into (Rotor is round with no flat spots except where the pinion goes). So, how is it sensored?

one other thing I touched the throttle once to determine that the magnet was slipping and the magnet turned as it should. If the sensors were attached somehow to the shaft, how could the magnet function without a sensor

If this fix fails i'm thinking about tring the 7xl I got without the sensors

	(#6)
crazyjr RC-Monster Dual Brushless Offline Posts: 3,794 Join Date: May 2005 Location: georgia	04.20.2006, 11:22 PM The windings are protected like an armature so i don't think they are damaged. What i wonder about is how the sensors work. i have looked everywhere except behind the end plate and don't see a sensor setup anywhere and nothing to key the rotor into (Rotor is round with no flat spots except where the pinion goes). So, how is it sensored? one other thing I touched the throttle once to determine that the magnet was slipping and the magnet turned as it should. If the sensors were attached somehow to the shaft, how could the magnet function without a sensor If this fix fails i'm thinking about tring the 7xl I got without the sensors Work because i gotta, play because i wanna People here hate Nitro, I love it. I start it, run it about 50 ft from me and it dies, I go after it. Perfect exercise Last edited by crazyjr; 04.20.2006 at 11:36 PM.