RC-Monster Forums - View Single Post

Serum · 05.22.2006, 03:55 PM

Yeah, I've got experience with multilayer prints. They are a pita .1 mm of paste already is too much IMO. The less the better..

i don't like that way of constructing either. if they used an aluminum plate to transfer the heat. In my case there is this fat 1-1.8 mm gap, with some silicone stuff just floating, only touching the fetts....

If i see something like that, with that amount of paste, i highly doubt if the person who assembled or did the quality control knew what he/she was doing. It's plain ridiculous.

	(#23)
Serum RC-Monster Admin Offline Posts: 10,480 Join Date: Feb 2005	05.22.2006, 03:55 PM Yeah, I've got experience with multilayer prints. They are a pita .1 mm of paste already is too much IMO. The less the better.. i don't like that way of constructing either. if they used an aluminum plate to transfer the heat. In my case there is this fat 1-1.8 mm gap, with some silicone stuff just floating, only touching the fetts.... If i see something like that, with that amount of paste, i highly doubt if the person who assembled or did the quality control knew what he/she was doing. It's plain ridiculous.