RC-Monster Forums - View Single Post

**Andys Monster 3 -** 04.03.2005, 03:37 PM

I placed the schulze not under the Pletti because the heat
goes in this position straight up to the pletti and both pletti and schulze gets too hot.

In this position I have a lot of space between the pletti and the schulz, so this stuff can "breath"...

+ I can mount a fan straight to the cooling fins of the schulze

+ I have a lot of space on the right side to mount the BEC

+ I have a much better low center of gravity, the only thing to get the max perfect
balanced is to use on the left side 4 more batteries than on the right side (under the pletti)

So my cell pack is left 10 and on the right side 6 (
I used 5,5 mm High Amp. Goldplugs... good for till 150 Ampere)

	(#3)
andy Guest Posts: n/a	Andys Monster 3 - 04.03.2005, 03:37 PM I placed the schulze not under the Pletti because the heat goes in this position straight up to the pletti and both pletti and schulze gets too hot. In this position I have a lot of space between the pletti and the schulz, so this stuff can "breath"... + I can mount a fan straight to the cooling fins of the schulze + I have a lot of space on the right side to mount the BEC + I have a much better low center of gravity, the only thing to get the max perfect balanced is to use on the left side 4 more batteries than on the right side (under the pletti) So my cell pack is left 10 and on the right side 6 ( I used 5,5 mm High Amp. Goldplugs... good for till 150 Ampere)