RC-Monster Forums - View Single Post

SpEEdyBL · 05.30.2006, 02:37 AM

Edit: It turns out my rotor wasn't out of balance at all. The rediculous amount of epoxy that I put on one side of the rotor, did nothing at all and I began to wonder. I found out that the earth's magnetic field was pulling one side of the rotor down towards the ground, since the balance point slightly shifted depending on which direction the shaft was pointing (North or South). I guess rotor balance is not the issue after all for feigao motors.

	(#29)
SpEEdyBL "Out of spec" enthusiast Offline Posts: 820 Join Date: May 2005	05.30.2006, 02:37 AM Edit: It turns out my rotor wasn't out of balance at all. The rediculous amount of epoxy that I put on one side of the rotor, did nothing at all and I began to wonder. I found out that the earth's magnetic field was pulling one side of the rotor down towards the ground, since the balance point slightly shifted depending on which direction the shaft was pointing (North or South). I guess rotor balance is not the issue after all for feigao motors. Check out my custom converted 8ight: Sub 7lb, lowest CG of any 1/8 buggy http://www.rc-monster.com/forum/show...894#post367894 Area 52 Ranch Raceway T.R.C.R.