RC-Monster Forums - View Single Post - Li-Saver Question

JOHNNYMAXXIMA · 01:56 AM

Ok. Only cause I don't want to mess anything up, I'm just making sure I've got this right, so bare with me. See if you can follow the spaghetti.
So Li-Saver #1 goes in to rx (bottom of pic), Li-Saver #2 plugs in to Li-Saver #1 (middle of pic), Y harness plugs in to Li-Saver #2 (top of Pic), then one esc to one side of the Y harness and the other esc to the other side of the Y harness (back down to middle of pic again).

So if everything is ok there, does it matter wich Li-Saver connects to wich esc?
Thanks.

	(#12)
JOHNNYMAXXIMA RC-Monster Dual Brushless! Offline Posts: 950 Join Date: Feb 2005 Location: Corona, Ca.	06.05.2006, 01:54 AM Ok. Only cause I don't want to mess anything up, I'm just making sure I've got this right, so bare with me. See if you can follow the spaghetti. So Li-Saver #1 goes in to rx (bottom of pic), Li-Saver #2 plugs in to Li-Saver #1 (middle of pic), Y harness plugs in to Li-Saver #2 (top of Pic), then one esc to one side of the Y harness and the other esc to the other side of the Y harness (back down to middle of pic again). So if everything is ok there, does it matter wich Li-Saver connects to wich esc? Thanks. Attached Thumbnails Last edited by JOHNNYMAXXIMA; 06.05.2006 at 01:56 AM.