RC-Monster Forums - View Single Post

neweuser · 01:52 PM

What's an easy way to remove the crank bearings? And is that common on a newer motor? I haven't had much luck with these trx 2.5's....my 3.3 is nice, no worries except it revs a little high off a high speed pass then goes to normal idle, not sure about that. But doesn't over heat and runs really well other than that.
Also, is there a better fuel tank or lid for the rustler? haven't found one yet, searched all that i can think of....

	(#9)
neweuser RC Monster, the Final Frontier Offline Posts: 3,379 Join Date: Feb 2006 Location: Minnesota	06.22.2006, 01:51 PM What's an easy way to remove the crank bearings? And is that common on a newer motor? I haven't had much luck with these trx 2.5's....my 3.3 is nice, no worries except it revs a little high off a high speed pass then goes to normal idle, not sure about that. But doesn't over heat and runs really well other than that. Also, is there a better fuel tank or lid for the rustler? haven't found one yet, searched all that i can think of.... "if you've got something to say, say it peacefully" Last edited by neweuser; 06.22.2006 at 01:52 PM.