RC-Monster Forums - View Single Post

sjcrss · 07.06.2006, 11:13 AM

I to would like to have more speed, but at what cost...bringing your controller to the brink of thermaling or thermaling or even a controller failure, you need to find a happy medium, I know it's hard, Well I've ran my system for 4 years and never had a issue with thermaling or anything, even after i switched to the UE diffs last August....the 9920 isn't much differant than the 2095 micro I'm running, other than the micro is programmable and the # of amps it can handle..the cell counts are the same....so the controller isn't the issue, it's the low rpm per volt on your motor...

	(#6)
sjcrss Hyper 7 Erevo Center Diff Offline Posts: 1,195 Join Date: Dec 2005 Location: CNY (Syracuse/Binghampton area)	07.06.2006, 11:13 AM I to would like to have more speed, but at what cost...bringing your controller to the brink of thermaling or thermaling or even a controller failure, you need to find a happy medium, I know it's hard, Well I've ran my system for 4 years and never had a issue with thermaling or anything, even after i switched to the UE diffs last August....the 9920 isn't much differant than the 2095 micro I'm running, other than the micro is programmable and the # of amps it can handle..the cell counts are the same....so the controller isn't the issue, it's the low rpm per volt on your motor...