[brijar]

Yeah, I've got a 9920 that the red programming jumper's mount has broken off. I tried soldering a couple of wires onto the circuit board where the jumper mounted, but as I don't have a very steady hand, it was rather weak and just broke off again. Then I tried soldering it on there, then putting 5 min epoxy over the joints to secure them, but now it has come off again. I sanded down the epoxy on the board to expose the spots again, but I'm not sure what to do right now. I definately can't afford a new ESC, and I don't really want to send it in to get it fixed. Is there any way to fix this that works good?

Thanx,
Brijar!!!