[brijar]

Well, I got un-lazy and tried to solder the right way. I tinned the spots on the circuit board and tinned the wires. Then I put the tinned wire on one of the tinned spots, and put my iron to it, and it went right on. I did that to the other one and just stripped the non soldered ends of the wires and twisted them together. It seems to be working great, but when I'm driving it around in my Rustler with 1 7-cell GP3300 battery because my Maxx is down right now, the truck will be going full throttle and just stop for about 1 second, then go again. It is very annoying, especially when you are trying to climb a 60* loose dirt hill with RWD and on-road tires:035:. I think this is cogging, but I'm not sure. I tried putting in a fresh pack, but it did it even worse. I'm charging my RX pack right now, so maybe that will cure it. It has never done this before in my Maxx or when I had it in my Rustler.

Thanx for the help,
Brijar!!!