RC-Monster Forums - View Single Post

sjcrss · 07.18.2006, 07:18 AM

I believe he followed the instructions and pulled the red wire from the servo plug on the end, and he was running a on/off switch on his UBEC, along with the on/off switch with the quark. I can understend how he is upset....he spent about a 1hr or so getting it to program right...then he runs it and it starts this on/off stuff after only 2 min. (thermaling)... he can drop 2 more teeth, but I don't think that will solve anything for him......and if he goes up then it more than likely will overheat more. I'm curious how you guys are running the quarks in the revo's......is it because they are a lighter vehicle. or what......I feel for ya man...

	(#17)
sjcrss Hyper 7 Erevo Center Diff Offline Posts: 1,195 Join Date: Dec 2005 Location: CNY (Syracuse/Binghampton area)	07.18.2006, 07:18 AM I believe he followed the instructions and pulled the red wire from the servo plug on the end, and he was running a on/off switch on his UBEC, along with the on/off switch with the quark. I can understend how he is upset....he spent about a 1hr or so getting it to program right...then he runs it and it starts this on/off stuff after only 2 min. (thermaling)... he can drop 2 more teeth, but I don't think that will solve anything for him......and if he goes up then it more than likely will overheat more. I'm curious how you guys are running the quarks in the revo's......is it because they are a lighter vehicle. or what......I feel for ya man...