RC-Monster Forums - View Single Post

Gustav · 10:11 PM

I got the rear diff assembled and the rear end back together and i don't see any problem at all,they're spot on.

I took the shafts down in the lathe to 3.5mm from the centre of the bevel gear pin hole,the same as the original outdrive.

All i had was 20k oil so i used that but only just over half full since it's a little thick.Now i just need my chassis to arrive and i'm ready to go.:027:

Off topic but I need a body to use on the non-extended g-maxx.Any suggestions? I want to cover the batts as much as possible,i know it won't cover them completely.

	(#1)
Gustav RC-Monster Aluminum Offline Posts: 916 Join Date: Jul 2005 Location: UK	07.19.2006, 10:08 PM I got the rear diff assembled and the rear end back together and i don't see any problem at all,they're spot on. I took the shafts down in the lathe to 3.5mm from the centre of the bevel gear pin hole,the same as the original outdrive. All i had was 20k oil so i used that but only just over half full since it's a little thick.Now i just need my chassis to arrive and i'm ready to go.:027: Off topic but I need a body to use on the non-extended g-maxx.Any suggestions? I want to cover the batts as much as possible,i know it won't cover them completely. Last edited by Gustav; 07.19.2006 at 10:11 PM.