RC-Monster Forums - View Single Post - Connectors or Direct solder for esc & motor?

jhautz · 07.20.2006, 06:06 PM

I usualy just take a fine file to the tinned wire and take off the high spots so it will fit into the connector. Its not removing much material, just enough of the high spots to get it to slip into the connector.

	(#35)
jhautz RC-Monster Mod Offline Posts: 4,217 Join Date: Apr 2006 Location: Chicago, IL	07.20.2006, 06:06 PM I usualy just take a fine file to the tinned wire and take off the high spots so it will fit into the connector. Its not removing much material, just enough of the high spots to get it to slip into the connector. I can't decide if its more fun to make it... or break it... Silent...But Deadly