RC-Monster Forums - View Single Post - Upper hole in tranny case not centered (motor side)

neweuser · 07.31.2006, 02:43 PM

go4gold is right, it's not the hole that centers your shaft, it's the bearings, so if they are aligned properly still you shouldn't have a problem. But i would still send it back because it should be proper. They can't fix the issue unless they know about it as well. If you still have the stock case, use that until you get your replacement. There is my 2 cents!

	(#3)
neweuser RC Monster, the Final Frontier Offline Posts: 3,379 Join Date: Feb 2006 Location: Minnesota	07.31.2006, 02:43 PM go4gold is right, it's not the hole that centers your shaft, it's the bearings, so if they are aligned properly still you shouldn't have a problem. But i would still send it back because it should be proper. They can't fix the issue unless they know about it as well. If you still have the stock case, use that until you get your replacement. There is my 2 cents! "if you've got something to say, say it peacefully"