RC-Monster Forums - View Single Post - Brushless e-maxx ?

OldSoldier · **Brushless setup -** 08.02.2006, 11:17 AM

Thanks Squee... I don't remember the Quark getting excessively hot, but I'll keep an eye on it... I was more concerned about the motor. I agree I need to put a smaller pinion on it. That should keep my motor and hopefully speed control cooler.

What about the front center driveshaft...think I need to upgrade to CVD? The rear upgrade is included in the FLM Extended Chassis kit.

	(#15)
OldSoldier E-ReVVo/SoldierMaxx Offline Posts: 71 Join Date: Aug 2006 Location: Maryland	Brushless setup - 08.02.2006, 11:17 AM Thanks Squee... I don't remember the Quark getting excessively hot, but I'll keep an eye on it... I was more concerned about the motor. I agree I need to put a smaller pinion on it. That should keep my motor and hopefully speed control cooler. What about the front center driveshaft...think I need to upgrade to CVD? The rear upgrade is included in the FLM Extended Chassis kit.