RC-Monster Forums - View Single Post

glassdoctor · **Neu motors -** 08.16.2006, 05:00 AM

I want to start a thread about these motors. I just got one to try in my buggy and truggy, and I will post some results when I get some wheel time.

Mine is a 1512 1.5Y

The initial brief test run showed the motor to run very cool, but we'll see what happens with a full run... bashing and on the track.

One FYI about the motors I picked up from the info that came with it... the smooth non-finned can motors apparently have a non-standard mounting screw spacing.

The finned cans have a standard screw hole spacing, but the smoothies have a smaller spacing... I think it was 25.2mm vs 22mm.

I don't have the sheet with me. I will correct that if it's wrong...

	(#1)
glassdoctor TEAM FUSION Offline Posts: 2,041 Join Date: Jul 2006 Location: Iowa... Hawkeye country	Neu motors - 08.16.2006, 05:00 AM I want to start a thread about these motors. I just got one to try in my buggy and truggy, and I will post some results when I get some wheel time. Mine is a 1512 1.5Y The initial brief test run showed the motor to run very cool, but we'll see what happens with a full run... bashing and on the track. One FYI about the motors I picked up from the info that came with it... the smooth non-finned can motors apparently have a non-standard mounting screw spacing. The finned cans have a standard screw hole spacing, but the smoothies have a smaller spacing... I think it was 25.2mm vs 22mm. I don't have the sheet with me. I will correct that if it's wrong...