RC-Monster Forums - View Single Post

neweuser · 09:46 PM

Do you recommend doing both the 5v and 3.3? Or just one or the other with the options you gave ?
The other question i have, is the parallel diagram, do you put two resistors one one red(any) wire, and two on one black(any) wire? Just want to make sure. I was thinking of just removing part of the covering instead of the whole end. Also, do you just connect them to the ends and then from the resister, they go to the board? Nothing on the end but the resistor? is that right?

	(#2)
neweuser RC Monster, the Final Frontier Offline Posts: 3,379 Join Date: Feb 2006 Location: Minnesota	09.09.2006, 09:41 PM Do you recommend doing both the 5v and 3.3? Or just one or the other with the options you gave ? The other question i have, is the parallel diagram, do you put two resistors one one red(any) wire, and two on one black(any) wire? Just want to make sure. I was thinking of just removing part of the covering instead of the whole end. Also, do you just connect them to the ends and then from the resister, they go to the board? Nothing on the end but the resistor? is that right? "if you've got something to say, say it peacefully" Last edited by neweuser; 09.09.2006 at 09:46 PM.