RC-Monster Forums - View Single Post

BrianG · 09.10.2006, 10:10 PM

That helped quite a bit for me. No more warm wires and the input voltage at the charger was higher.

However, this will require opening the charger and desoldering/resoldering on the circuit board. I am sure this will void any warranty, so be warned.

Another way to go about it would be to shorten the existing wire to about 2 or 3 feet. This obviously won't change the gauge, but will still reduce the voltage drop, if not as much as replacing the wire altogether.

	(#8)
BrianG RC-Monster Admin Offline Posts: 14,609 Join Date: Nov 2005 Location: Des Moines, IA	09.10.2006, 10:10 PM That helped quite a bit for me. No more warm wires and the input voltage at the charger was higher. However, this will require opening the charger and desoldering/resoldering on the circuit board. I am sure this will void any warranty, so be warned. Another way to go about it would be to shorten the existing wire to about 2 or 3 feet. This obviously won't change the gauge, but will still reduce the voltage drop, if not as much as replacing the wire altogether.