The screws were tough to get out. On my 5700 motor, I didn't actually get it open because one of the screws really didn't want to come out. But after I got the screws out of my 4600, I ended up tapping the endbell off by gently hitting the motor shaft against the workbench.
Quote:
|
Originally Posted by andywpj
the MM motor is like same HIMAX HA36 series i think.
|
These motors seem like they are too good of quality to be less expensive/cheap (Chinese?) airplane motors.
SH Z-Car, Custom Crawler, 8s Savage,
12s XTM XLB 1/7 buggy,
4wd 4-link rear/IFS Pro4 truck,
Custom Hyper 10 Short Course,
Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz