Quote:
|
Originally Posted by neweuser
How are you guys getting the Quark apart anyways?
|
If you are talking about how to open the case, in the center on of the top plastic piece between the plastic and aluminum casing, stick a small sharp flat sharp screwdriver, opening the aluminum casing just enough for the top plastic piece (there is even a small slot there like it was made for a screwdriver to fit) to come outward.
Quote:
|
I'm alittle curious about the new Mamba Maxx. I have a brand new in the box Quark and a Quark with like two runs on it. I'm going to Ebay one of them to get some cash to buy a Mamba and check it out. I'm running 4s lipo and a two pole motor which is the only short coming of the Mamba maxx (low volt rating and no 4 pole motors). Its cheeper than buying a Neu motor and I love my Mamba 25.
|
I love the Mamba Max, but the Quark I believe just feels better overall for 1/8. When I had the MM in my buggy over all it works pretty good, it just feels smaller. Not quite as much take off power. Occasionally, from a standstill to full throttle would give you just some clicking as if I was holding the buggy. Hard to explain. If you have a light 1/8 setup it would probably be ideal.