RC-Monster Forums - View Single Post - aluminum tranny case- stampede

MetalMan · 10.12.2006, 09:38 PM

The suspension arm mounts (hinge pin carriers) aren't supposed to be countersunk. The only thing that should be countersunk is the group of 4 3mm screws on the thin plate that attaches to the main part of the gearbox.

I too don't know what the 4mm locknuts are for (there are only 2 of them, right?), but I would guess that they go above the suspension arm mounts to secure the mounts.

	(#3)
MetalMan RC-Monster Mod Offline Posts: 5,297 Join Date: Mar 2005 Location: SoCal	10.12.2006, 09:38 PM The suspension arm mounts (hinge pin carriers) aren't supposed to be countersunk. The only thing that should be countersunk is the group of 4 3mm screws on the thin plate that attaches to the main part of the gearbox. I too don't know what the 4mm locknuts are for (there are only 2 of them, right?), but I would guess that they go above the suspension arm mounts to secure the mounts. SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz