RC-Monster Forums - View Single Post

starscream · 07:45 PM

Hmm, I thought there was a mod you could do.
I ran my Quark with a BEC without making any changes.
I see in the instuction manual that the OPTO Modification says to disconnect or remove the the middle red wire from the pin of the receiver socket.
This may be a dumb questions but ,what does removing the red wire do?

	(#5)
starscream RC-Monster TQ Offline Posts: 703 Join Date: Mar 2005	10.16.2006, 07:43 PM Hmm, I thought there was a mod you could do. I ran my Quark with a BEC without making any changes. I see in the instuction manual that the OPTO Modification says to disconnect or remove the the middle red wire from the pin of the receiver socket. This may be a dumb questions but ,what does removing the red wire do? Ha Ha The Flashlight Strikes Again... Last edited by starscream; 10.16.2006 at 07:45 PM.