[skellyo]

Here's my comments as well as pricing I found on the parts themselves:

Novak HV-Maxx 4.5 ($304.99) - Ok, but I like sensorless better...can be cheaper too
Traxxas Wheelie Bar ($17.59) - Wouldn't spend my money on it
Traxxas Red Wheels for Wheelie Bar ($18.39) - Wouldn't spend my money on it
Traxxas Aluminum Transmissionskid plate ($16.59) - FLM skid is cheaper
Traxxas Aluminum Lower Braces ($53.99) - FLM is cheaper
Traxxas Aluminum Battery Hold Downs ($29.99) - Wouldn't spend my money on it - I'd go with GMaxx straps instead...cheaper too
Traxxas Machined Motor Plate ($17.59) - Wouldn't spend my money on it
Traxxas Lightweight Input Shaft ($13.39) - Wouldn't spend my money on it
Traxxas Lightweight Idler Gear Shaft ($3.39) - Wouldn't spend my money on it
Traxxas Lightweight Output Gear Shaft ($10.99) - Wouldn't spend my money on it
Traxxas Suspention Pin Set Titanium ($21.49) - These are ok, but the stainless pins will work just fine for half the price
Traxxas Big Bore Shocks ($63.99) - These are ok, but I like threaded shocks myself
Traxxas Bulkheads F/R ($123.98) If you meant the aluminum ones. - Wouldn't buy these...would go FLM instead
Gorilla Maxx G3 Race Skids ($39.00) From Mike here at rc-monster - These are ok, but I like the FLM prices a bit better....not to mention better warranty
FLM Bulkhead Braces F/R ($18.00) From Mike also - These are ok
CVD Centers ($45.99) - These are ok
T-Bonz CV Drive Shaft Set ($60.00) From Mike also - Step up to MIP instead...much better investment
Hitec HSC-5955 Titanium Gear Servo ($114.99) - Good servo

FWIW, I'd stick to the parts you really need when you upgrade to brushless, rather than those wanted for the bling factor.