RC-Monster Forums - View Single Post

BrianG · 11:26 PM

Thanks Meat. I'll be waiting a while before purchasing the motor/ESC/batts, so I can take my time to do other stuff right. Still tough with a hacksaw, dremel, and files to work with.

Well, it's kinda like that dense cutting board material you'd find in places like Subway where they make the sandwiches. Sorta translucent at the edges, like it's made of slightly watered down (or skim) milk. It's a little difficult to work with. It's cuts sort of OK, but cleaning up the edges in a PITA. Will dye work on that kind of material? I know, that explanation was not very exact, eh?

	(#8)
BrianG RC-Monster Admin Offline Posts: 14,609 Join Date: Nov 2005 Location: Des Moines, IA	10.23.2006, 11:25 PM Thanks Meat. I'll be waiting a while before purchasing the motor/ESC/batts, so I can take my time to do other stuff right. Still tough with a hacksaw, dremel, and files to work with. Well, it's kinda like that dense cutting board material you'd find in places like Subway where they make the sandwiches. Sorta translucent at the edges, like it's made of slightly watered down (or skim) milk. It's a little difficult to work with. It's cuts sort of OK, but cleaning up the edges in a PITA. Will dye work on that kind of material? I know, that explanation was not very exact, eh? Last edited by BrianG; 10.23.2006 at 11:26 PM.