RC-Monster Forums - View Single Post - my e-revo and dremel dilemma

Finnster · 10.27.2006, 02:59 PM

Haha, couldn't resist. :)

Seriously tho...

I made a mount similar to what you need to make a mount for my rollbar.

Did you buy a 3mm tap? I just used a ~(1/4 or 3/8")x ~1" x whatever piece of plastic (some scrap UHMWPE from conv) trimmed to make an angled block (~same shape as Daf's alu piece.) I just then drilled and taped 3mm holes (dont have to tap, but its nicer/stronger) so I could run the servo screws thru. You could do a similar thing, but add retaining nuts to hold servo on.

Should be fairly easy. Alu is pretty and blingy; plastic is cheap, light and easy.

	(#19)
Finnster KillaHurtz Offline Posts: 2,958 Join Date: Apr 2006 Location: Bucks Co, PA	10.27.2006, 02:59 PM Haha, couldn't resist. :) Seriously tho... I made a mount similar to what you need to make a mount for my rollbar. Did you buy a 3mm tap? I just used a ~(1/4 or 3/8")x ~1" x whatever piece of plastic (some scrap UHMWPE from conv) trimmed to make an angled block (~same shape as Daf's alu piece.) I just then drilled and taped 3mm holes (dont have to tap, but its nicer/stronger) so I could run the servo screws thru. You could do a similar thing, but add retaining nuts to hold servo on. Should be fairly easy. Alu is pretty and blingy; plastic is cheap, light and easy.