RC-Monster Forums - View Single Post - First look at the single speed E-Maxx conversion kit

RC-Monster Mike · 05.22.2005, 09:40 AM

I have built three of these so far. I cut the shaft with a hacksaw and remove the burr with a dremel. Unless you are Stevie Wonder, it is not hard to make it work(no offense to Stevie Wonder:)). If the end isn't perfectly straight, it doesn't matter as long as it doesn't rub on the inside of the tranny case. The cut part of the shaft is inside a bearing.

	(#69)
RC-Monster Mike Site Owner Offline Posts: 4,915 Join Date: Nov 2004 Location: PA	05.22.2005, 09:40 AM I have built three of these so far. I cut the shaft with a hacksaw and remove the burr with a dremel. Unless you are Stevie Wonder, it is not hard to make it work(no offense to Stevie Wonder:)). If the end isn't perfectly straight, it doesn't matter as long as it doesn't rub on the inside of the tranny case. The cut part of the shaft is inside a bearing.