RC-Monster Forums - View Single Post

RC-NUT · 11.16.2006, 08:17 PM

LOL

I cheated. First I extruded the inner diameter of the circle so I had a blank circle at the desired thickness. Then I measured the size of one tooth and created it on the same plane. Next I used my favorite command "pattern mirror" using the circular pattern. I used that command to create 55 teeth and checked off "equal spacing." The axis of the circle drove the command.

Make sense?

	(#10)
RC-NUT RC-Monster Carbon Fiber Offline Posts: 121 Join Date: Oct 2006 Location: SANDOWN, NH	11.16.2006, 08:17 PM LOL I cheated. First I extruded the inner diameter of the circle so I had a blank circle at the desired thickness. Then I measured the size of one tooth and created it on the same plane. Next I used my favorite command "pattern mirror" using the circular pattern. I used that command to create 55 teeth and checked off "equal spacing." The axis of the circle drove the command. Make sense?