RC-Monster Forums - View Single Post

Serum · 11.24.2006, 02:07 PM

Yeah, i understand what you mean..

If you just make it hot enough, it would be a good connection, but you need to pay close attention on the other side of the circuitboard, to see if the tin is melting on that side too..

While you are at it, you might as well put the output of the UBEC directly on escs receiver wire I was planning on doing that with my mamba-maxx. What bec did you get? i got one with a very small footprint, which would blend right in..

	(#13)
Serum RC-Monster Admin Offline Posts: 10,480 Join Date: Feb 2005	11.24.2006, 02:07 PM Yeah, i understand what you mean.. If you just make it hot enough, it would be a good connection, but you need to pay close attention on the other side of the circuitboard, to see if the tin is melting on that side too.. While you are at it, you might as well put the output of the UBEC directly on escs receiver wire I was planning on doing that with my mamba-maxx. What bec did you get? i got one with a very small footprint, which would blend right in..