RC-Monster Forums - View Single Post

MetalMan · 01.25.2007, 02:16 AM

I know the bearing hole isn't 10mm, I said if you drill it to 10mm you could use a 5x10mm bearing in the spur. The hole is almost 10mm though, so minimal drilling is required, decreasing the chances of the hole being drilled off-center.

I did this with the custom slipper clutch setup for my X-Terminator 1/8 buggy (Revo slipper clutch + MGT spur) so I know it works.

	(#18)
MetalMan RC-Monster Mod Offline Posts: 5,297 Join Date: Mar 2005 Location: SoCal	01.25.2007, 02:16 AM I know the bearing hole isn't 10mm, I said if you drill it to 10mm you could use a 5x10mm bearing in the spur. The hole is almost 10mm though, so minimal drilling is required, decreasing the chances of the hole being drilled off-center. I did this with the custom slipper clutch setup for my X-Terminator 1/8 buggy (Revo slipper clutch + MGT spur) so I know it works. SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz