RC-Monster Forums - View Single Post

jhautz · 01.25.2007, 11:06 AM

It has 2 separtate wires that go directly to the pack leads. Thats where it reads the voltage from. The 3 wire plugs are for control signals and 6v power only. It doesnt read voltage from there. It would only read the 6V from the BEC on those wires.

I'm just not sure what it deos to ''cut off'' the power to the esc. Does it just shut it down? or just block the signal pulses from the Rx to the ESC? Does it need the red wire to do this?

	(#8)
jhautz RC-Monster Mod Offline Posts: 4,217 Join Date: Apr 2006 Location: Chicago, IL	01.25.2007, 11:06 AM It has 2 separtate wires that go directly to the pack leads. Thats where it reads the voltage from. The 3 wire plugs are for control signals and 6v power only. It doesnt read voltage from there. It would only read the 6V from the BEC on those wires. I'm just not sure what it deos to ''cut off'' the power to the esc. Does it just shut it down? or just block the signal pulses from the Rx to the ESC? Does it need the red wire to do this? I can't decide if its more fun to make it... or break it... Silent...But Deadly