RC-Monster Forums - View Single Post

BrianG · 01.28.2007, 04:48 PM

Thanks guys!

@sleebus: With Lexan scissors, then using a dremel sanding wheel for the fine stuff. As you can imagine, it took a while. I'm sure if you look closely, you'll see a couple imperfections. Also, one of the holes is about 1/4mm off center, but since the 3mm holes were drilled with a 1/8" bit, there is enough play to make it work. If this doesn't leak when in use, maybe Mike can make up a rubbery-type batch for non-Kyosho diffs?

@***RC***: It's going to be primarily for racing. And it has to look pretty as well as perform. :)

	(#148)
BrianG RC-Monster Admin Offline Posts: 14,609 Join Date: Nov 2005 Location: Des Moines, IA	01.28.2007, 04:48 PM Thanks guys! @sleebus: With Lexan scissors, then using a dremel sanding wheel for the fine stuff. As you can imagine, it took a while. I'm sure if you look closely, you'll see a couple imperfections. Also, one of the holes is about 1/4mm off center, but since the 3mm holes were drilled with a 1/8" bit, there is enough play to make it work. If this doesn't leak when in use, maybe Mike can make up a rubbery-type batch for non-Kyosho diffs? @*RC*: It's going to be primarily for racing. And it has to look pretty as well as perform. :)