Quote:
|
Originally Posted by baehan
serum...thanks for the help. is it a bad idea to wait on replacing the bulkheads and towers until the current ones need to be replaced? the motors and controller are stock. i may go brushless when the motors go bad. what am i looking at spending on a brushless setup? any recommendations on parts?
|
Welcome! Well, there seems to be a lot of aluminum on there for stock. The thing is, with Integy parts, they LOOK nice, but have no strength. if you are going aluminum, go FLM as they are the best bang for the buck. As far as set up for BL, that would depend on what you are looking for and the batts you are going to use. The batts are everything, so get good batts! A nice start up system for BL would be the 9920 or MM, ubec and 7xl on 14cells of good batts, like GP 3300's. I run an RC18T in my apartment, good litle truck, but if are racing it, you may want something bigger! lol
Also, with BL, you may want to beef up your drive train, a good inexpensive way to do this is go 3.3 stock stuff....can't beat it! So, if you want a good buck for the bang, get FLM bulks and towers, RPM or stock 3.3 arms and shafts, single speed tranny, maybe even an FLM chassis would be good too. That's all I can think of right now...LOL
Serum beat me to the punch on this!!! LOL :)