RC-Monster Forums - View Single Post - MetalMan + BP-Revo BL Revo Bash

MetalMan · 02.13.2007, 01:07 AM

The first Revo picture is just after it went through that water (you can see water dripping under it). The next Revo picture is just after the water, and the tires are flinging the water off.

There wasn't any water jumping, but at one point my buggy managed to hit that puddle and get the receiver wet. I had to wait about half an hour for it to dry out (it's my only receiver).

The buggy is my X-Terminator, back from the dead :D. And yes, it's BL. In some of the pics you can see some wires, and no cooling head.

I'll make sure to tell Wes about these comments on the pics.

	(#23)
MetalMan RC-Monster Mod Offline Posts: 5,297 Join Date: Mar 2005 Location: SoCal	02.13.2007, 01:07 AM The first Revo picture is just after it went through that water (you can see water dripping under it). The next Revo picture is just after the water, and the tires are flinging the water off. There wasn't any water jumping, but at one point my buggy managed to hit that puddle and get the receiver wet. I had to wait about half an hour for it to dry out (it's my only receiver). The buggy is my X-Terminator, back from the dead :D. And yes, it's BL. In some of the pics you can see some wires, and no cooling head. I'll make sure to tell Wes about these comments on the pics. SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz