RC-Monster Forums - View Single Post

01:50 AM

more bad news.. another run today, and while doing a 4wd doughnut (cyclone), one of the packs ejected it's self..

i knew that this would be a problem from the last time a pack ejected it's self, so i used 2 zip ties on each pack, to keep it from sliding out sideways.. well both zip ties broke, and were no where to be found.. and the pack slid a good 40 feet from the car..
there's a copper colored ribbon that wraps around the connector end of the pack, and that got damaged.. is that cable for balancing? or ? there's pack didn't puff or anything like that, just a little knick. what should i do now? send it back to true-rc to rebuild the pack? or is that even needed?
picture:

	(#192)
A4DTM Guest Posts: n/a	03.16.2007, 01:49 AM more bad news.. another run today, and while doing a 4wd doughnut (cyclone), one of the packs ejected it's self.. i knew that this would be a problem from the last time a pack ejected it's self, so i used 2 zip ties on each pack, to keep it from sliding out sideways.. well both zip ties broke, and were no where to be found.. and the pack slid a good 40 feet from the car.. there's a copper colored ribbon that wraps around the connector end of the pack, and that got damaged.. is that cable for balancing? or ? there's pack didn't puff or anything like that, just a little knick. what should i do now? send it back to true-rc to rebuild the pack? or is that even needed? picture: Last edited by A4DTM; 03.16.2007 at 01:50 AM.