[glassdoctor]

Here's a clip from another forum:

Ok, I got a dumb question. I worked on going through the manual setting mode, which wasn't too bad, but it seemed to end early. Trying to set the speed to not have reverse at all, and I wanted to know if you select this option, is step 3, Reverse Amount, no long gone through?

Also, when I get to the end of all the settings, I get a single repeating beep. Is this the last mode or is it something else? Nothing in the manual describes this.

I tried it again, and basically it does go through all the steps. I hooked it up to my pc and confirmed all the settings.

I sent this to support:

> 1. I am attempting to manually configure my mamba max system, and the
> last setting only gives single beeps instead of the multi beeps based
> on what part you are on. Is this correct?
>
> 2. If I select a drive configuration without any reverse, do I still
> need to go through the reverse power selection part?

RESPONSE:

#1 That's an error, we're fixing it. It's still setting the correct
motor type, etc. It's just beeping once instead of 9 times.
#2 You would still have to even though it wouldn't effect anything.

So it appears that it's programming vorrectly... but the end-program beeps are messed up....