RC-Monster Forums - View Single Post - Project B-S

Serum · 06.28.2005, 05:29 PM

Perhaps the pawl is tightened too hard.. Or the pawl is stucked inside the aluminum part.. does it shift with the wheels spinning free in the air? (note; with electric you allmost don't hear it shift)

Did you tried adjusting the shifting point? with BL you can keep that point very low. (make it shift into 2nd at 15 mph or so)

	(#5)
Serum RC-Monster Admin Offline Posts: 10,480 Join Date: Feb 2005	06.28.2005, 05:29 PM Perhaps the pawl is tightened too hard.. Or the pawl is stucked inside the aluminum part.. does it shift with the wheels spinning free in the air? (note; with electric you allmost don't hear it shift) Did you tried adjusting the shifting point? with BL you can keep that point very low. (make it shift into 2nd at 15 mph or so)