Align 600L with a Quark 65 Roadster

[lincpimp]

Alrighty then!

I have a fresh (to me!) hyper8 buggy that I plan on testing my align 600l motor in. Now I have a few maxamps 2100 based packs, enough to do 6s 4200 mah. So I plan to mount the motor where the gas tank would go, and make a pair of battery trays in the rear on either side of the rear chassis brace.

Methinks I can use one of my trusty quark 65 roadster escs to motivate this beasty. Here are the specs from align on the motor, 1620kv, and a 65 amp max. Now I know that the max amp rating is not based on land vehicle usage, just the trex600 heli.

http://www.align.com.tw/shop/product...oducts_id=1383

And the quark 65 is supposedly good for 65amp constant, 90 amp surge and 150 amp spike, so I figure it may be able to keep up?!

http://www.rc-monster.com/proddetail...oadster&cat=21

65amps at 6s would be almost 2hp, which were the highest recorded spikes in my 7xl, 4s powered buggy. I am guessing that adding an extra cap would be a good idea. Maybe I will add a heatsink to the case too.

Let me know what you guys think...