Maxx RPM Knuckles | 16mm Bearings

[ANGRY-ALIEN]

Hi all... I want to find out if anyone has tried the above before... what were you methods for fitting a 16mm bearing in a 15mm hole?
What were the pros and cons of this mod? I ran RPMs recently with some offset hubs and it didn't look like it was doing well with the
weight of my truck... It seems like the bearings had a tiny amount of play in the knuckles and were exaggerated with the offset hubs...

I will be employing CRT x1 CVDs for my Maxx in the near future and i wanted an axle carrier that will facilitate large bearings this since
the shafts OD is 8mm...

Any insite will be helpful...

Alien