FLM Bulkheads- oh dear, oh dear....

[suicideneil]

So, my FLM bulkheads finally arrived from 2coolrc- yippee! But then I opened the parcel and..... whoever is in charge of quality control should be shot. Look at this:-


rear outside face


rear inside face


front outside face


front inside face

They are absolutely covered in machining marks, and the screw holes were filled with swarf which I had to clean out with my M3 tap thingy. And the worst bit is the hole made by the cnc cutter as it cut the groove which lets you tighten up the output cup. It went to deep and went right through to the hinge pin hole/ channel. This is seriously poor craftmans ship, and the fact the little bag the parts came in still had bits of swarf flaoting around in it makes me wander if the parts are just taken from the cnc and put in a bag for sale without any checks being done.

2coolrc also made me mad by sending some generic 14mm alloy hexes which arent integy, since integy ones have there logo printed onto them, and no pins were included either- I have to buy some from ebay.... Not a happy bunny.