I received my BL ! What I should do??! - RC-Monster Forums

Quebecois_Sti · **I received my BL ! What I should do??! -** 03.29.2005, 05:33 PM

Hello,
I just received my BL order (MGM controller 80 amp with Feigao 8s), good job Rc-Monster, well packed and fast shipping (in 5 days to Canada).

Now I want to know where to weld the motor on the speed control ?

There is "A" "B" "C" connections (yellow wire) on the controller and the motor is with wire red, green and yellow. Where I weld it ? Any where to any connections ?

Nick · 03.29.2005, 05:39 PM

It is best to solder the ESC straight to the motor with no connectors, this gives less resistance.

Sorry I know little about anything else - just a quick reply so you can try and get the beast running. :P

phildogg · 03.29.2005, 05:42 PM

just hhok up the three wires to the three blue wires coming off the controller,if the motor runs in reverse just change two wires around. then you need to program the controller to your radio. there are instructions on the site for the programming hope this helps ya some.
phil

HotnCold · 03.29.2005, 05:51 PM

Pdog is correct - if your motor is running backwards - changing 2 leads will correct the prob - any two leads will do....

Quebecois_Sti · 03.29.2005, 06:14 PM

I don't find the instructions/user guide on the site, only user guide for the Warrior...

I plug the yellow wires of the controller to any wire of the motor ? It cannot break something ?? I don't understand so much what you are talking about (I'm not so good in English...)

HotnCold · 03.29.2005, 06:25 PM

Yes - the 3 wires from motor to the 3 motor leads on controller - if motor is spinning the wrong way - change any 2 of the wires...

Quebecois_Sti · 03.29.2005, 06:50 PM

ok..
I check and at the begin, the motor was turning and I was checking in what way to be. I find the correct turning way but I just go take a pinion to be sure of the way and now the controller is always do : BEEP BEEP BEEP and the green LED is flashing at the same time. My throttle of my transmitter is to the lower. And after if my problem will be fix, how I will adjust the controller to my transmitter ? I have no user guide give with and I search few minutes on google and I found nothing.

thx to help. I want to test it :D

HotnCold · 03.29.2005, 07:03 PM

1 second for the fix

Quebecois_Sti · 03.29.2005, 07:07 PM

I think I find the user guide !
is it this : http://www.wattsup.co.nz/pdfs/TMMEXP...manual_ENG.pdf

?

RC-Monster Mike · 03.29.2005, 07:13 PM

I just e-mailed the instruction. That link is also the instructions (this is in your e-mail). LMK if you need any further assistance.

phildogg · 03.29.2005, 07:43 PM

sorry bro I thought you had the bk controller ..oops my fault.
phil

Quebecois_Sti · 03.29.2005, 08:33 PM

thats ok now...!
Thanks Mike for the fast support!
My car is now ready, I will try it!

RC-Monster Mike · 03.29.2005, 08:41 PM

Have fun!