Receiver wire - RC-Monster Forums

brijar · **Receiver wire -** 02.20.2006, 06:34 PM

I just recently got my 9920/9L combo for my E-Maxx. I have soldered everything to the best of my ability with the Motor wires going straight to the motors(not mixed up(i.e. left to left, center to center, ect.)). I wired the batteries in series just like Mike said in the programing thread. The receiver wires are orange, red, and brown when looking at the side of the connector with the shinny plugs. Right now, I have the orange wire as the signal wire. Is the orange or the brown wire the signal wire? I'm having a little bit of trouble programing it. I have charged my 13 GP3300 cells. I have removed the BEC jumper. I have one battery plugged in. Then I remove the red programing jumper. Then I turn on the transmitter, folowed by the receiver. After that, I plug in the other battery. It will beep once, then I hold full throttle, but it won't beep again. Any help would be appriciated.(sorry for the long post:013:)

Thanx,
Brijar!!!

brijar · 02.20.2006, 07:47 PM

Never mind everyone. I figured out my servo reversing switch was the wrong way so the ESC thought I was going backwards:013:. I just got back from running and I have some more issues which I will put in a new post.

Happy Maxxin',
Brijar!!!

HotnCold · 02.20.2006, 08:10 PM

Brijar - Good to see you figured it out - and Welcome to the RC-Monster Family

02.20.2006, 08:54 PM

Welcome to the forums

coolhandcountry · 02.20.2006, 11:26 PM

brown is ground. good to hear it working. Hope you work other issuses out.