Warrior 9918 .. when will it be in stock again?

I need a controller for my 9L motor. The Warrior 9918 seems to be the most popular choice for a controller. But it has been out of stock for a month. Is there any other alternative controller available?

Also, for the connections, is WS deans Solder any good, I think it has included flux in it. This will be my first time soldering any tips would be appreciated

THank you

[RC-Monster Mike]

It hasn't quite been a month, but it has been too long! They should arrive this week. WS Deans solder is perfect. I have some in stock, as a matter of fact(I suppose I should list it in the store!).
Welcome to the forums, too!

[RC-Monster Mike]

These are back in stock.

[squeeforever]

so did the 9920 replace the 9918? or is it just a upgraded version? i wish i would have waited cause i just paid 220 for a pre-wired 9920 since you had been out of them for so long.

[RC-Monster Mike]

The 9920 replaced the 9918. they are basically the same controller, except the 9920s have dual wires now(similar to the 120+ amp controllers, but smaller gage wire).

[squeeforever]

dual wires?

[RC-Monster Mike]

Yes, dual wires. Instead of one 12 gage wire for each battery lead and motor lead, there are now 2 smaller wires in their place.

Thanks for the speedy delivery Mike. I guess the dual wires are more efficient than just one.

Is there a website with photos and instructions on how to wire this to the BEC, Batteries, motors, reciever, etc?

[RC-Monster Mike]

No pictures, but there is a detailed instruction stuck at the top of the brushless forum here:
http://www.rc-monster.com/forum/show...?s=&threadid=8