Specs on Lehner 1920 - RC-Monster Forums

**Specs on Lehner 1920 -** 10.04.2007, 10:37 PM

Doese anyone know if the guy at Finedisign has any of the Lehner 1930 or 1920 motors in stock?
I have been sending them an e amil every day this week but still no reply.

While i am here doese anyone have any specs on the Lehner 1920 motors.
Had a look at the Lehner specs page but the 1920 was not listsed.
Just after the rpm/Volt specs and Watt rating of them. I know the 1930 are 1200W and the 1940 are 1400W but not sure on the 1920.

The other thing is the 1930/5 rpm/Volt specs. The chart only goes down to 1930/6.

The motor is only going to be run on 3s. So looking for about 40,000rpm. It is to go into a Jato.

BrianG · 10.05.2007, 12:17 AM

LMT 1920/7: 4688
LMT 1920/6: 5227
LMT 1920/5: 6272

46mm long x 26mm diameter, 1/8" shaft diameter.

For more specs, check out the LMT site.

Asking about a competitors product probably isn't the best thing to do here. I would keep on emailing or call him. The fact that he is not answering product questions should give you an idea about his customer service though...

BP-Revo · 10.05.2007, 12:37 AM

Quote:

Originally Posted by BrianG

Asking about a competitors product probably isn't the best thing to do here. I would keep on emailing or call him. The fact that he is not answering product questions should give you an idea about his customer service though...

Well, there is really a point to that...WHAT customer service...

zeropointbug · 10.05.2007, 12:51 AM

.......yeah... it's an oxymoron when referring to FD...

lincpimp · 10.05.2007, 01:23 AM

Does anyone think that Chris ever reads any of these posts?

Does anyone care?

I don't!

Hickoryhead · 10.05.2007, 01:35 AM

I will admit he was nice to talk to.

His knowledge goes against most everything you read on this forum.

You need to decide what to think of him for yourself.

Here's a thread about my experience:

http://www.rc-monster.com/forum/showthread.php?t=7597

There have been members that have had good service with him. Coolcountry speaks highly of him. But for the most part

!!!!!

Chris told me at the beginning of September that he did not have any 19xx serious motors in stock and would not be getting any in until next year maybe not at all.