hey, finially a little video action of my LS10

[tashpop]

upfront, i had the quality turned down on the cam because i used a small sd card. its runnnig 4s2p a123 mm mmbec 10L feigao mashers2000 and a hpi mt bug body i just installed this morning. i've been mostly concentrating on my emaxx and this has been 2nd choice since day one. i really like how it drives. so much more predictible and nimble over the maxx. any ways, no high speed runs on here, although i got pretty close to top speed a time or two. i found out today i may be a bit under geared. the motor is running a little on the warm side and the esc is dead cold.

any ways here's a pic.


vid 1
http://s39.photobucket.com/albums/e1...essLS10003.flv

vid 2 (has a couple of back flips)
http://s39.photobucket.com/albums/e1...essLS10004.flv

[jnev]

That thing is awesome!! Looked like a tad too much power in the 1st video... Is the LS10 a pretty tough truck overall?

[MetalMan]

Those backflips look like fun . However, they might be a good indication of the undergearing of the truck that you mentioned.

[rootar]

looks like it runs like mine does, ihave snapped or twisted to hell 6 dogbones now and 3 drive cups are gone.........Ive had my fun with those type of backflips for now lol. ive backed the slipper off and have the punch control set to 40% and it still lofts the front wheels at speed. How many dogbones have you gone through???

[tashpop]

only 1, i haven't really had much seat time, and i try not do too many backflips, because i know its hard on it. i've been thinking that if the dogbones continue to warp, doing some searching for some thicker ones. i'm sure there's an option outthere somewhere.

[rootar]

the stock ones are 6x84 i found some 7x84 and some 8x84 (savage center dogbone) dogbones i dunno if the ends would be to big to fit the drive cups tho so i didnt order them. If someone else on here with an ls10 that also has a savage or a friend with a savage could to check that out and let us know?

[MTBikerTim]

I can measure them for you. I have a couple of worn out sets lying around.

[rootar]

tim i need to know the diameter on the drive pins, the ball end they are in, and the length over all and the length pin to pin......if you could thatd be great

thanks

[neweuser]

Nice vids. looks real fun to drive!