32 pitch 5mm bore pinions

anybody have any advice I have 5mm motor shaft as many of you probably also have. and i need 32 pitch pinions. thanks

[hoovhartid]

http://www.rc-monster.com/proddetail...od=32pinion5mm

should be in stock soon--shoot mike an e-mail
mike@rc-monster.com

[JThiessen]

You can also buy here (if/only if Mike is sold out!)
http://www.robinsonracing.com/catalog/catalog.html

[Arct1k]

I don;t think the RRP ones are 5mm...

[JThiessen]

Lower right hand corner of the page - for brushless motors. They only carry ".8 Mod" and Mod 1. Some on here claim that .8 mod is the equivelent of 32P - and I have yet to hear someone contradict that.

[Arct1k]

You are correct.... sorry didn't see the new section

Looks like they are super hard which I don't recall mikes being.

[BrianG]

Yeah, Mod 0.8 is actually 31.75 pitch. I've used a mix of a mod 0.8 spur (jato) with a 32p pinion forever and everything works fine.

You guys seem to be on top of eveything. I've been doing some homework and yes RRP only has mod .8 and mod1 it looks like the mod .8 will definatly work and I've seen that Brian had actually posted on anothe thread about how they work well. I've ordered some from Mike and because they are not hardened I will also be getting some from RRP, But Mikes should be here soon so they should keep me going till I get some others. Mikes just came into stock the day after I posted this Thread and he was on top of it and sent me a msg. letting me know. Thanks for all the help. If any body else is using the mod .8 please post and let us know how they work

the pinions i recieved from Mike are awsome would highly recomend