servos is working but not the 2200KV, what's up?

This is strange

I have just installed the MMM comb with 2200KV, and calibrated the ESC. To my surprise the 2200KV doesn’t move at all when I push on throttle on my Futaba 3PM 2.4G.

The Futaba BLS451 Brushless High-Torque servos is working fine but the 2200KV is not working. What can I have done wrong?

PS I get those” ring” sounds and beep from the engine thought?

Please help me

[BrianG]

It's a Futaba so you need to reverse the throttle channel. Then recalibrate the ESC and radio.

As usual, I must say a big thank you to all the fine people on this forum Excellent. What would I be without you?

So I took my LiPo's back to my charged for a check, and one of them was fully completed, empty (3.2 volts, it was long since I drove hmm one year in fact).

I also made a check on my transmitter to ensure that it was set correctly, and it was not (hmm very wrong here).

Now for the fun part, everything is super good and working, just waiting for some final parts to complete this creation.

I was actually scared when I tested the throttle on the transmitter, I just pushed max 2mm and the entire chassis was in the rollover.

I’m in love LOVE!!!