VXL motor Q

[fastbaja5b]

Hey guys I have a VXL motor in my rc to run the heatsink I want tho I need to remove the rear plastic thing and 2 of the 4 2.5x5mm button screws

Is this a dangerous thing to do? I know the Medusas / Neus all seem to have pressed in endbells and these VXL ones seem pretty tight

[suicideneil]

Dangerous, no. Two screws on opposite sides of the endbell would be best, but two next to each other is okay- the endbell aint gonna just pop off with those inplace. I would say though is it possible to dremel the heatsink where the screws would be underneath the heatsink? (picture?)