Tie rods for TNX

Hi I am looking for new tie rods That will hold up to bashing?

[RC-Monster Mike]

I will see if I can find some Lunsfords for you, Daniel.

Thank you !! :D

[RC-Monster Mike]

I must say, your TNX is one of the nicest I have seen. I was drooling when I posted the pictures in the forum. very nice truck.

Thank you very much! That makes me feel good!!

[RC-Monster Mike]

Do you race at all? Perhaps you will come up to the barn this summer and do some racing on our outdoor track. It is a ton of fun.

I have done little Racing last year untill they told me I could not race there any more:C: I also found out that the T-Maxx and Revo guys Had some thing to do with it at the track:mad: I just could not gess why!!! I gess Traxxs is very big there.
I would like to come by and check it out some time.:D
Thank you Mike,
Daniel Muray
:D :) :D

[RC-Monster Mike]

Where did they tell you you couldn't race? So I know not to go there!

IT was On Traxs in Brown Mills NJ.
I was told it is under new Owner now but I have not been back there to check on it.I gess I should see if it is under new Owners?

[RC-Monster Mike]

Well, Lunsford has not made the titanium turnbuckles for the terra crusher or TNX. I have my distributor searching to see if Tamiya offers them. Hopefully, we can find a set. If I think of it(and have a few minutes), I will measure the length and see if I can find a suitable replacement.

Hi,Mike they are 90mm long I hope this helps
Thank you,
Daniel Murray

[RC-Monster Mike]

Yes, that helps. I will see what I can dig up. Are they 90mm from end to end, or is the turnbuckles itself 90mm?

The turnbuckles itself 90mm long
Thank you Mike,
Daniel Murray