Receiver wire/antenna tube question

I picked up a brushless revo and the guy that I got it from was using dms so he didn't have to worry about the receiver wire. So the truck doesn't have a spot for the antenna tube to go. Just wondering if anyone has any ideas as to what I can do to secure the antenna tube in place so I don't end up wrecking my receiver wire.

Thanks

[magman]

Try one of these...http://www.amainhobbies.com/product_..._id/23951..the wire gets pinched in between the cap and base...just put a small "o" ring between them to protect the wire as you tighten the screws down. Good luck!

you can use the Tekno RX box it has a holder for the antenna tube to

http://www.impaktrc.com/product_info...products_id=46