Brushless Jammin!!!

Hey guys, I'm going to be building up a brushless Jammin X1-CR Buggy! Anyone have experience doing it? I think it's going to be relatively simple to do, I'm going to make a mounting plate over the center diff (replacing stock). The center plate is going to be the hard part, I'll probabely bang one out in bronze plate first as a prototype and then get a machinest to make it (I may even sell it if it works well). Well, just wanted to get this thread started to document progress and get some input!

[squeeforever]

i believe blackhawk444 is also doing this. what brushless setup are you goin for?

[MetalMan]

If it uses the standard Ofna diff, then you can use the plastic spur gear from Kyosho for the Landmaxx. cspurlock uses it on his Ofna differentials, and I too will be using one on a Hyper 7 diff in my 1/8 buggy.

[Serum]

The spur from the landmaxx is rather tough too, it is that red spur right? with the steel collar? it eats its way thru the pinions.

[MetalMan]

I don't think it is a red spur gear. cspurlock has it on the Hyper 8 in this thread:
http://www.rc-monster.com/forum/showthread.php?t=2868
That gear is black.

[vad]

Originally Posted by MetalMan

I don't think it is a red spur gear. cspurlock has it on the Hyper 8 in this thread:
http://www.rc-monster.com/forum/showthread.php?t=2868
That gear is black.

Kyosho has two plastic gears. The one form the landmax is IF147 which is a 44T, and the mp-7.5 sport buggy uses the IF148 which is a 46T. Landmax use to have a red gear, but not sure what the tooth count on that is.

[squeeforever]

i did a little research and the only one i could find was red.